Programming New Locks in the Lock View

This section describes how to program new locks in iLOQ Manager.

When a new lock cylinder is delivered from the factory, it is in the factory state, and can be taken into use in any iLOQ S50 Locking System.

This is the usual way of adding new locks. However, you can also add lock through the floor plan. See Adding a New Lock onto the Floor Plan.

Proceed as follows.

  1. Select Basic data > Browse locks.

  2. Select the locks to be programmed.
  3. Right-click to select Program lock.

    The Programming of locks wizard is opened.

  4. Select Program locks.
  5. A list of locks to be programmed is shown.
  6. Select Next.
  7. Select Program locks.
  8. Select Next.
  9. A summary screen is shown.
  10. Select Ready.
  11. A status screen is shown, displaying the lock that is next in the programming queue.
  12. Follow the instructions on the programming status screen.
  13. A summary screen is shown.
  14. Select Close.
  15. The programmed locks appear in the lock grid view in the Programmed state.
A
A-P is the author of this solution article.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.