Open navigation

Adding Locking System Information

This section describes how to upload a floor plan and add general information on the locking system, used when generating the common access rights and apartment locks.

Proceed as follows.

  1. Select Locking System Information.

    The screen below is opened:

    Figure: Locking System Information
    Locking System Information
  2. Select how to handle Access rights.

    The options are:

    • Stairwells have shared access rights — If you select this option, a single set of common areas is generated and that set is shared between all the stairwells.

      This is the default option.

    • Stairwells have own access rights — If you select this option, common areas are not shared, and a common area is created for each stairwell. Add the number of stairwells in the Number of stairwells field.

  3. Select how to handle the Apartment numbers.

    The options are:

    • Running numbering — A running apartment identifier is used.

      If you select this option, the running number is increased by one for each apartment.

      This is the default option.

    • By stairwell — Apartment identifiers are stairwell-specific.

      If you select this option, you must input the range of apartment identifiers for each stairwell. Add the number of stairwells in the Number of stairwells field, and the apartment identifier ranges in a table such as the one below:

      Figure: Apartment Identifier Ranges
      Apartment Identifier Ranges
  4. Select Add access rights.

    Continue from the next deployment step.

R
Rosalind is the author of this solution article.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.