Fetching Audit Trails by Loading an Offline Log Reading Task to the Programming Key and Visiting the Locks


Proceed as follows.

  1. Connect your Programming key to your computer.
  2. Select Basic data > Audit trail reading state.

    Make sure that the Audit trail reading state button is activated.

  3. Disconnect the Programming key from the computer.
  4. Go to the site with the Programming key.
  5. Connect the programming cable to the Programming key.
  6. Insert the lock programming cable into the lock that you wish to read audit trails from.

    Wait until the green status led on the Programming key is illuminated.

  7. Remove the lock programming cable from the lock.
  8. If necessary, repeat steps 6-7 until audit trails have been read from all the desired locks.
  9. Connect the Programming key back to the computer.
  10. Login to iLOQ 5 Series Manager.

    Soon, a reply message is displayed in the lower right corner of iLOQ 5 Series Manager.

Can’t find what you are looking for?

Send a support request, and you will be connected to our expert

Send a ticket