1×2
With the Relay card, you can control one or two devices through the relay outputs K1 and K2.
The available relay modes are:
- Toggle
- Impulse
- Key hold
- Roller door
In this configuration, it is possible to specify the relay outputs that a particular access right has the right to control. A valid key can, therefore, activate either both or only one of the relay outputs K1/K2.
In the impulse relay mode, the impulse length is reset, if a valid key is read in the Key reader again, even if the previous impulse is still active. In other words, the calculation of the delay starts from the beginning.
Note:
You cannot use button inputs BUTTON1 / BUTTON2 in this configuration.
