Defining inputs and outputs for N507 Net Bridge
This section describes how to define inputs and outputs for an N507 Net Bridge in iLOQ 5 Series Manager.
The Net Bridge N507 can be configured as a stand-alone I/O card to operate a door with direct calendar controls or input controls.
Proceed as follows.
- Select .
- Select the desired N507 Net Bridge.
- Right-click to select Properties.
- Open the Devices tab.
- Select the IO module.
- Right-click to select Edit I/O controls.
The Modify network module I/O controls wizard is opened.
- Select Edit.
- Select either Relays 1X10 or Relays 1X20.
- From the left, select the desired input number and output number.
Here, you define the relations between inputs and outputs. One input can command several outputs, if needed.
Also, give a name for the output, and select the Mode and Operating time for the relay.
See Preparing N500 Net Bridges.
- Click Ready.
