Operation Mode 1

This operation mode is intended for connecting one or two networked lock cylinders, which control relay outputs.

An example use case is an alarmed door, or a door where a magnet lock is bypassed by a valid key insertion to the lock cylinder.

Opening the cylinder with a valid key, or activating the push button, activates the relay output that bypasses the door magnet contact, or opens the magnet lock, for a fixed time of 30 seconds.

In this case:

  • The Door Module is not programmed.

  • Relay outputs K1 and K2 cannot be calendar-controlled. The idea is to prevent bypassing an alarmed door from iLOQ 5 Series Manager.

  • Door status cannot be connected.

The table below describes the inputs controlling outputs K1 and K2, and whether the outputs are calendar-controllable.

Table 1. Operation Mode 1
K1 K2 DOOR STATUS
L1 X
L2 X
IN1 X
IN2 X
Calendar

You can deploy this installation according to the instructions in Connecting Remotely Controlled Lock Cylinders. However, set the OPTIONS dip switches as follows:

S1 OFF
S2 OFF
S3 ON
S4 ON
S5 OFF

Can't find what you're looking for?

Please note that iLOQ does not manage its customers' iLOQ locking systems.

If you need a new key (digital or phone key), have lost your key, or want to check the access rights of your key, please contact the administrator of the locking system (Property manager / Maintenance company / iLOQ Retailer).

Send request