Open navigation

Programming Locks through the Programming Token

This section describes how to program locks through the Programming Token memory at the site.

Proceed as follows.

  1. Transfer one or more lock programming tasks to the Programming Token.
  2. You can logout from iLOQ Manager, if you want.
  3. Unplug the Programming Token from the computer.
  4. Go to the site with the Programming Token.
  5. Connect the lock programming cable to the Programming Token.
  6. Connect the lock to be programmed to the Programming Token by inserting the lock programming cable into the lock.

    Wait until the green status led on the Programmer is illuminated.

  7. Remove the lock programming cable from the lock.
  8. If necessary, repeat steps 6-7 until the desired locks have been programmed.
  9. Connect the Programming Token back to the computer.
  10. Login to iLOQ Manager.
  11. Soon, a reply message is displayed in the lower right corner of iLOQ Manager.

    When the reply message is received, the executed programming tasks are automatically removed from the Programming Token memory.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.