This section describes how to remove keys from the blocklist on iLOQ Manager.

1. Select Basic data > Browse blocklist.

   

    
2. Select Remove from blocklist.
   The Remove from blocklist wizard is opened.
3. Select Remove keys from the blocklist.
4. Select the key(s) that you want remove from the blocklist.
5. Select Next.
6. Select how to proceed with the keys affected.

   The options are:

   • Leave in planning state — Select Leave in planning state if you want to leave the blocklist in the planning state, and order it later. After this, the blocklist status will be In planning.

     A blocklist left in the planning state is indicated by an orange Order blocklist button in the Ribbon.

     Note:

     So far, you have just removed the key from the block list, but the new blocklist version has not been sent to the keys, which will spread the list over to the locks. When you want to send the new blocklist version to the keys, see Ordering a Blocklist.

   • Order blocklist — Select Order blocklist if you want to order the blocklist. After this, the blocklist status will be Ordered.

7. Select Next.
8. A summary screen is shown.
9. Select Ready.