This section describes how to program locks through the Programmer memory at the site.

1. Transfer one or more lock programming tasks to the Programmer.
   See Managing Programmer Content.
2. You can logout from iLOQ Manager, if you want.
3. Unplug the Programmer from the computer.
4. Go to the site with the Programmer and the token.
5. Switch on the Programmer.
6. Connect the lock to be programmed to the Programmer by inserting the lock programming cable into the lock.

   Wait until the green status led on the Programmer is illuminated.

7. Remove the lock programming cable from the lock.
8. If necessary, repeat steps 6-7 until the desired locks have been programmed.
9. Connect the Programmer back to the computer.
10. Login to iLOQ Manager.
11. Soon, a reply message is displayed in the lower right corner of iLOQ Manager. When the reply message is received, the executed programming tasks are automatically removed from the Programmer memory.