Select your region or visit global site

Support
Open navigation

2x8

Relay modules A00.11 are connected to the Relay card RS232-1 and RS232-2 buses, whereupon you can use 16 additional relay outputs. A key can simultaneously control 1-16 relay outputs of the Relay module.

The available relay modes are:

  • Toggle
  • Impulse
  • Key hold

In the impulse mode, the default length of the Relay module impulse is 8 seconds.

In this configuration, it is possible to specify the relay outputs that a particular access right has the right to control. A valid key can, therefore, activate 1-16 relays of the Relay module. In addition, a valid key always activates both relay outputs K1 and K2 of the Relay card.

When the relay mode is impulse, and if a valid key is read in the Key reader, while the previous impulse is still active, the Relay module’s relays will be set according to the relay combination of the last valid key. In other words if, for example, relay output 3 has been activated by key 1 when the control is still on, key 2, which controls for example, only relays 4 and 5, will be read. In this case, relay 3 will stop activating, whereupon only the relay combination of the last key, that is, 4 and 5, will be activated.

The Relay card outputs can also be activated with a potential-free contact signal (for example, a push button) to input Button1. In this case, relays K1 and K2 will behave according to the selected relay mode in the same way as with a key. The Relay module relays cannot be controlled with button input Button1.

See also Appendix 4 - Wiring Diagram for R10S.3 A00.11 2x8.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article

Didn't find what you were looking for?

Submit a ticket