Select your region or visit global site

Support
Open navigation

RFID Reader N104

RFID Reader is a device located in the vicinity of a door. RFID Reader is connected to the Door Module READER RS-485 bus; it has no other connections. RFID Reader is used to control an electric lock by an iLOQ key equipped with an iLOQ RFID tag.

If RFID Reader is equipped with a keypad, it can be used to provide access to the door with a code only.

When installing:

  • If you place the readers closer than 10 cm from each other, or install the reader on a metal surface, the reading distance can be shorter.

  • If you install two readers close to each other, we recommend installing a sheet metal plate between the readers.

  • Do not install a reader to the vicinity of strong electromagnetic disturbance sources.

  • Do not cut the cable shorter than 10 cm.

  • You can leave the wires not mentioned in the connection instructions disconnected. However, these cables must not be in short cut with each other.

  • If installed directly on a metal surface, the reading distance may be shortened. To avoid this, we recommend using installation plate A10.119 between the door and the reader.

The connections are:

  • Red wire — DC+

  • Black wire — DC-

  • White wire — A

  • Green wire — B

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article

Didn't find what you were looking for?

Submit a ticket