This section describes how to replace imported floor plans to iLOQ Manager.
If your floor plan changes due to, for example, renovation, you can replace the existing floor plan with a new one, without losing the lock placements.
Note:Mandatory fields are marked with an asterisk (*).
Proceed as follows.
- Select .
- Select Add floor plan.
The Importing of Floorplan wizard is opened.
- Select Replace existing floor plan.
- Click the ... button and select the file that contains the new floor plan.
- Select Next.
- The next options depend on the image file type.
If your floor plan is a PDF file:
- Select the Page number where the desired floor plan is on.
- Select the desired Resolution for the imported figure.
If your floor plan is an image file in, for example, the PNG format:
- Check that the figure looks as planned in the preview.
- Select Next.
- Check the image file size in the Size field.
If the file size exceeds 1 MB:
- Select Back.
- Select a figure with a smaller file size or, in the case of a PDF file, reduce the Resolution for the imported figure.
- Select Next.
- Select the floor plan that will be replaced.
- Do not rename the floor plan.
- Select Next.
- A summary screen is shown.
- Select Ready.
- Select Close.
- The figure is uploaded on the server.
- Check that the figure is sharp enough.
If the figure is not sharp enough, replace the figure again.
- If the replacing floor plan is of a different size than the original, and the locks are on incorrect locations, you can move the lock in their correct positions all at once. See Dealing with Re-scaled Floor Plans.